How truSculpt 3D Works

Trusculpt 3D is an innovation radio frequency device that gives the skin deep heat. Your technician uses this to cause the fat cells to die, thus creating non-invasive fat reduction body sculpting/contouring treatment. In the process it can also reduce the appearance of cellulite. It is designed to treat almost any area of the body. A sample of areas include the abdomen, flanks, thighs, buttocks, neck, arms and other stubborn regions where fat lingers. Trusculpt 3D is comfortable and requires no anesthetic. Most patients describe as a hot stone massage and others report almost no sensation of heat at all.

During a treatment a small hand piece releases radio-frequency energy. This is placed over the targeted area and a small surrounding area. This energy causes fat cells to heat up and programs them to liquefy and be removed through the lymphatic process after dying. The energy released from the heat also causes skin contraction for a slimming and smoothing effect on the skin. There is no down time with this treatment, allowing you to return to your normal activities immediately following the treatment. Patients will see significant improvement approximately 8 weeks following 1 Trusculpt treatment and full results up to 3 months after. Additional sessions may be required to obtain desired results if more than usual results are expected.

After a brief pre-treatment preparation, the Trusculpt 3-D handpiece is applied to the skin. The handpiece will deliver a pulse of radio frequency energy area. The handpiece will then be moved to another treatment area to which the process will be repeated. The Trusculpt 3-D system is designed to provide an easy and relaxed procedure for non-invasive fat removal and body sculpting/contouring. The small issues that can arise include redness, swelling and mild tenderness in the treated area. Bruising in the area does occur but rarely. Usually most of the side effects resolve in an hour.

A unique advantage of the Trusculpt 3D is that it is well documented to help tighten lax skin because of the radio frequency energy.  Radio frequency has been used for many years as an energy source for tightening facial skin. Modifying how the energy is delivered by the Trusculpt 3-D, lets the device decrease fat and tighten the skin at the same time.

Trusculpt vs Coolsculpting

Trusculpt 3D improves the skin tone in the treatment area and could be considered a treatment for fat and laxity in the skin. Coolsculpting has not proven to make the laxity worse, however it does not help the laxity of the skin.

The cost to perform Trusculpt is less for the provider, therefore the cost to the patient is less.